• Hydraulic / Pneumatic drive
• Blank Plate Support System
• Detachable drive unit
• Emergency shut-off facility
• Pushers - Coil Spring
• No need of cooling
• Sophisticated Gas delivery system through Mononozzle without chance of any blockage
• Tube Guides for perfect alignment

• SES (Tube ) changer with Stopper Control
• Quick change of SES (Tube) without stopping the cast
• Tube change without raising the tundish
• Tube change in less than 2 seconds
• Tube change at above the minimum casting speed for most steel grades/slab sizes
• Increased safety by virtue of emergency shut-off facility (blank plate)
• Argon direct injection in the upper part of the mononozzle significantly decreases alumina clogging unlike other systems
• Argon injection onto sliding surface of mononozzle inhibits air ingress
• Longer sequence without the need to use large complex pouring tubes
• Less tundish movement on the floor or with the crane

• Increase in the number of heats per tundish and per sequence length
• More heats per day due to less downtime
• Increased caster productivity by less slab down-grades
• Less accumulation of skull
• Labour and energy saving due to less tundish requirement
• Reduced overall refractory cost due to longer tundish sequence life
• Reduced operating cost due to high reliability and very less spares